Lewis Chainsaw Winch Model 400

You looking to find the "Lewis Chainsaw Winch Model 400" Good news! You can purchase Lewis Chainsaw Winch Model 400 with secure price and compare to view update price on this product. And deals on this product is available only for limited time.

   

Product Description

Turn your chainsaw into a portable winch. Simply take off your bar and chain and attach the Lewis Winch and you have an incredibly powerful pulling unit. The Lewis Winch is handy for winching small logs for firewood, pulling game animals from remote locations, slash clearing, even pulling a car out of a ditch, there are hundreds of uses. The Lewis Winch 400 MK2 fits most all chainsaws. You should have a 3 cubic inch (50cc) saw or more to get maximum use of your Lewis Winch. It will pull up to 4,000 lbs. with a larger saw (5 cubic inch / 85cc) and the line speed is approximately 60 ft. per minute. Comes complete with 150' of 3/16" cable with hook. Anchor chain and saw not included.

Lewis Chainsaw Winch Model 400 Review

If you need a portable powered winch, your options are severely limited. Honda makes a capstan winch for pulling fiber rope where this is a reel winch pulling wire rope. Maybe the Honda is a better choice, but I haven't run one and can't say.

There is a serious problem with the winch that has to do with connecting it to your chainsaw. I think it's much better to use it with a chainsaw that has an internal clutch because you can use the adapters that come with it to connect directly. But chances are your saw has an external clutch so you have to use the drive chain. The motor generates more torque when you're running the winch than when you're sawing wood, so the bar slips up and down. If it slips one way the chain flies off; if it slips the other way the chain tightens up so much it won't slide along the bar. You'd strip the threads on the studs before you'd get it tight enough to stay in place. So you should be prepared to make some spacers out of 1/2" x 1/8" steel bar to put inside the bar's slot where the bar studs go: drill holes in them for the bar studs.

Another problem I'm having is that the wire rope developed tight coils after a few uses. I can't just let the wire rope loose after unhooking from a load because it will spring together in a tangled mess. I don't know what caused that or what the manufacturer could do to prevent it, but it's a big problem anyway.

Another problem is threading the wire rope back onto the reel. Under load, when the rope is threading on one side, it takes a lot of muscle power to aim the winch to get the rope back toward the middle or over to the other side.

The manufacturer advertises that you can get more pulling power if you have a bigger motor. So bigger is better, right? But sooner or later you're going to pull on a load that doesn't budge. So now you have to get the tension off by releasing the clutch so you can unhook from the load. But if you have too much tension you can only release the clutch by pounding on the handle. Normally you push on the handle or tap on it to move a tension pin out of a detente and then turn it. But if there are thousands of pounds of tension in the wire rope then you have to hammer on the clutch to release it. What all that means is that you probably don't want to use a saw much bigger than 3.5 cubic inches or 60 cc.

Should you buy one? If you're looking at this item it's probably because you need something like it. For all its problems, I don't know of something better. Maybe the Honda.

Most of the consumer Reviews tell that the "Lewis Chainsaw Winch Model 400" are high quality item. You can read each testimony from consumers to find out cons and pros from Lewis Chainsaw Winch Model 400 ...